This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRFgo Studio and nRF52840 programming

Hi Everyone,

I just purchased an nRF52840 PDK and I am trying to program it via nRFgo. I erased the flash, selected the latest s140_nrf52840_5.0.0-3.alpha_softdevice.hex and using the soft device tab I try to program it on the PDK. I get this "The flash is not erased" message which is strange because I just erased the flash and the flash erase operation was confirmed:

image description

Any suggestions are greatly appreciated!

Thanks!

Parents Reply
  • Also, I cannot upgrade the JLINK firmware:

    New firmware: J-Link OB-SAM3U128-V2-NordicSemi compiled Jul 24 2017 17:30:12 Current firmware: J-Link OB-SAM3U128-V2-NordicSemi compiled Feb 12 2016 12:15:53 Starting bootloader... Waiting for emulator to detach... OK after 182ms. Waiting for emulator to attach... Timeout. ERROR: Communication timeout. Emulator did not re-enumerate. ERROR: Firmware update failed.

    Tried in boot mode too, it looks it is programming it, but it is not.

    Thanks!

Children
No Data
Related