NRF52840 Thread example power down 10 mins after USB disconnect

[meetandyhere]

Hello,

I am trying the Thread Cloud COAP Client

<InstallFolder>\examples\thread\experimental\cloud_coap_client

on a NRF52840 PDK. I'm using Thread SDK v0.10.0. The example works as described.

However, when I unplug the board from USB, it goes into some kind of power down mode in approx. 10 minutes and loses connection to the Thread network. I can see LED1 is still on, but it is extremely faint. It is flickering, so trying to connect to the network, but it cannot do so. After a further 5-6 minutes of this, LED1 goes completely off.

I had a few questions about this behaviour:

1. Where in the code can I set the time between USB disconnect and going in power-down mode?
2. I know that the NRF52840 has System ON and System OFF power modes. Where in the code can I set which mode it should go in?
3. Is the behaviour of it not being able to connect to the Thread network when in low power mode expected? If so, can I change this behaviour or is there a fix planned?

Thanks in advance!

Regards

Andy

[meetandyhere]

Right now the roles are automatically assigned. I have a network of three NRF52840s, where one of them is a NCP attached to Raspberry Pi and the others are nodes. When a node is joined, I can see in the Thread Topology Manager that it is a end node initially, but after a few seconds becomes a router. Making the node a sleepy end device is a good idea - could you tell me how I can force a node to become a sleepy end device? Some changes in the code?