Using stm32 disco board for flashing a custom nrf52832 chip with keil

[MikeLemon]

Hello there,

I'm trying to flash my custom nrf52832 pcbs(untill I get my DKs in the tech tour with a reconfigured stm32 disco board's SWD port with keil uVision using the blinky blank example in SDK 14.0 (Already have S132 of those chips and I know the SWD port works sins I was able to flash some stuff to it with arduino but with the ST link V2 dongle which is not supported by keil(what a shame)).

now when I try to download the build example from keil I get this error message:

and here is what the PC sees when connecting ST link to the pc:

Thanks for helping.

[endnode]

Yes, SEGGER don't provide you full version of J-Link OB for free, it releases it for cheap boards like STM32 Dev Kits or nRF5x DK boards but implements internal check of the target and limits it only to the brand of Dev Kit. If you get nRF5x DK and upgrade to latest SEGGER J-Link OB firmware you will get the same error when trying to flash/debug targets from other vendors then Nordic. However this feature is fairly recent so if you find some >1 year old SEGGER J-Link OB firmware for your STM32 board it might work without this internal lock to ST Micro targets. Good luck.

[MikeLemon]

Yeah probably not their bad in particular but most options that are supported make you but the expensive segger programmer or the DK... now I don't know how to use OCD to program my chip(also can't find a proper tutorial on using it with eclipse with the ST link V2(or anyother SWD programmer)(although I set it up for NRF52 up until the flash part) so I give up probably waste another 100$ on the DK's that I will probably use once and count on that.