This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

No Source Available for "0x01e054"

I've been noticing lately when running debugging on my code, a few minutes in it loses connection and says No Source Available for "0x01e054". I'm sure how to even figure out the source of this. Typically in the past I would see then when initially setting up a project and the linker file is incorrect. However I doubt that I have a memory issue now. Any suggestions? Thanks guys.

Parents

0 Dave_couling over 7 years ago

Any input from Nordic? I have only noticed this when I am using TWI to poll a sensor. This is in addition to running ADC sampling at 100hz and sending notifications. Everything runs fine without TWI. But it seems when adding the TWI module, the debug goes haywire and there is a Stack Corruption as some random point in time (between 3mins and 30mins of operation).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Dave_couling over 7 years ago

Any input from Nordic? I have only noticed this when I am using TWI to poll a sensor. This is in addition to running ADC sampling at 100hz and sending notifications. Everything runs fine without TWI. But it seems when adding the TWI module, the debug goes haywire and there is a Stack Corruption as some random point in time (between 3mins and 30mins of operation).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data