How to use SHT1x sensor?

[sosse]

I just figured it out it is not I2C protocol. I need to write all the command by Bit-Bang mode. How can I send/receive data with manual bit command to SHT1x sensor? Can anybody share any library for SHT1x sensor or Bit-Bang mode?? I am using nrf51822 with SDK11 (S130). THank you!

[John]

Hi,

I've had to bit-bang an SHT75 and SHT1x interface on several processors including the nRF5x chips. Unfortunately that code belongs to my employer and I cannot share it. That said, it is a simple matter of controlling a couple of GPIO pins to do the work. The folks at Sensirion do provide example code for you though. Take a look here:

SHT example code

Good luck!

John

[sosse]

Hi, Thank you for the answer. But my question is the DATA pin line should be set as output and input, right? is it possible to switch output and input during the command? something like as follows..

//-----enter code here-----------------------------------------------------------------------------
char s_write_byte(unsigned char value)
//----------------------------------------------------------------------------------
// writes a byte on the Sensibus and checks the acknowledge 
{ 
  unsigned char i,error=0;  
  for (i=0x80;i>0;i/=2)             //shift bit for masking
  { if (i & value) DATA=1;          //masking value with i , write to SENSI-BUS
    else DATA=0;                        
    _nop_();                        //observe setup time
    SCK=1;                          //clk for SENSI-BUS
    _nop_();_nop_();_nop_();        //pulswith approx. 5 us  	
    SCK=0;
    _nop_();                         //observe hold time
  }
  DATA=1;                           //release DATA-line
  _nop_();                          //observe setup time
  SCK=1;                            //clk #9 for ack 
  error=DATA;                       //check ack (DATA will be pulled down by SHT11)
  SCK=0;        
  return error;                     //error=1 in case of no acknowledge
}

this code to changed to

//----------------------------------------------------------------------------------
char s_write_byte(unsigned char value)
//----------------------------------------------------------------------------------
// writes a byte on the Sensibus and checks the acknowledge 
{ 
  unsigned char i,error=0;  
  for (i=0x80;i>0;i/=2)             //shift bit for masking
  { if (i & value) nrf_gpio_pin_set(SHT_DATA_pin);          //masking value with i , write to SENSI-BUS
    else nrf_gpio_pin_clear(SHT_DATA_pin);                        
    __NOP();                        //observe setup time
    nrf_gpio_pin_set(SHT_SCK_pin);                          //clk for SENSI-BUS
    __NOP();__NOP();__NOP();        //pulswith approx. 5 us  	
    nrf_gpio_pin_clear(SHT_SCK_pin);
    __NOP();                         //observe hold time
  }
  nrf_gpio_pin_set(SHT_DATA_pin);     
	
	//release DATA-line
  __NOP();                          //observe setup time
	nrf_gpio_cfg_input(SHT_DATA_pin, NRF_GPIO_PIN_NOPULL);
   nrf_gpio_pin_set(SHT_SCK_pin);                            //clk #9 for ack 
	
	error = nrf_gpio_pin_read(SHT_DATA_pin);
   nrf_gpio_pin_clear(SHT_SCK_pin);        
   return error;                     //error=1 in case of no acknowledge
}

am I doing something wrong?? I got error all the time.