I'm wondering which is the proper way to adjust the ANT power level?
I've seen some posts that seem to suggest that the proper way is by the use of the the BLE Gap call:
err_code = sd_ble_gap_tx_power_set(TX_POWER_LEVEL);
APP_ERROR_CHECK(err_code);
But also some references to using the ANT call:
// Configure Tx power for master chanel
err_code = sd_ant_channel_radio_tx_power_set(RS_CHANNEL_NUMBER, RADIO_TX_POWER_LVL_4, 0);
APP_ERROR_CHECK(err_code);
Appreciate any clarification on this.
Note: I'm using an nRF52832, S332 [4.0.2] SoftDevice, and 13.1 SDK.
Thanks! -Tim