NRF52840 BLE transfer using NUS service

[pranavsk1994]

I am writing an application for sending data received over SPI from a non-nordic chip to nrf52840 to nrf uart app using NUS service. I am using 20 bytes of a packet size the max in NUS. The SPI sampling happens at 4 MHZ. I am receiving a very low throughput of around 2.88kbps. Can anyone guide me how to change BLE setting to maximize the throughput

[endnode]

The question is what are both ends of your BLE link, who is Master (GAP Central), what Connection Interval is used and whether you are able to change this. Normally NUS on any nRF5x chip should be able transport at least 3 packets at 7.5ms interval which (being 20B each) gives you at least 8kBps (64kbps). But indeed if one side of the link is some Android phone with 48.75ms interval and single packet per interval then indeed maximum throughput will be around 3.2kbps.

[endnode]

Sure, simply call the function until it will return different error code then OK. Then wait for TX_COMPLETE event and repeat the procedure.