cannot open port with nrf connect

[Ashish]

hi everyone, I've downloaded s140 and trying to run BLE notification example. I'm able to see state changes in the advertising on putty terminal at COM 7, but when I try to connect port using nRF Connect, it always display same message :

Would you like to program development kit on COM 7 with required firmware ?

It selected it OK, the program on chip stops working. Again repeating the procedure lands me into same results?

[Joakim Jakobsen]

Hi Ashish!

It wont work to connect the same board that has your notification example on it. You need to connect an additional nRF5 DK to your computer with USB, program the development kit with the required firmware, and then use that to scan for your peripheral with the notification example.

You can read more about nRF Connect Bluetooth low energy in the infocenter.
These sections would be of special interest of how to connect a device, scan and establish a connection:
Establishing serial port connection to a local device
Establishing Bluetooth low energy connections

Hope that clears things up. Let me know if you have any questions.
Best regards,
Joakim.

[Ashish]

Hi !

I've read the tutorials, I tried to run simple ble_app_blinky example. It works perfectly with Android app nrf_blinky , but when I tried to test it using nRF_Connect, I'm getting same issue with connecting port.