ANTWare II and NRF 52

[Pradeep]

Hi,

I have programmed s212 soft device onto to NRF52 DK and also programmed ant_broadcast\tx application onto the NRF52 DK. The LED is glowing to indicate that TX is happening. NRF52 DK is connected to my laptop using the USB cable.

When I start ANTWare II application, no device is detected by this app. Am I missing something obvious here ?

Is it possible to connect NRF52 DK to ANTWare II app?

Regards, Pradeep

[Jørgen Holmefjord]

See this thread. This also applies to the nRF52.

[Pradeep]

Thanks for the quick response. This thread says that I will have to buy ANTUSB-m (2 to be specific), to set up client and server communication over ANT Protocol through ANTWARE II.

After a lot of searching in the forums and also reading through all the documentation for ANT, I am still not clear as to how do I setup NRF 52 DK for ANT protocol.

My requirement is to transmit few bytes of data from a few slave nodes (upto 5) to a master node, may be one to one connectivity between Master & Slave or through a Mesh Network. I have seen a lot of documentation claiming that this can be achieved, but I am unable to dig out any reference to information as to how to do this using ANT protocol using NRF 52.

I would be of great help if you could point me to the proper information to achieve my goal.

Thanks. Pradeep