This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Secure DFU bootloader: application not starting

Hello,

I have a problem with secure bootloader. what I did:

  1. Flash SoftDevice 130 using nRFgo Studio.
  2. Compiling \examples\dfu\bootloader_secure\ (i removed the error regarding the key).
  3. Flashing the bootloader with Keil (using nrfjprog.exe for flashing).

Unfortunately, the bootloader seems not to run. There is no advertisement "DfuTarg". When I compile the buttonless dfu example and flash it with Keil, there is still no response. So the bootloader does not start the application. There are no debug messages over UART either.

However, when I flash the precompiled debug version (secure_dfu_secure_dfu_ble_s130_pca10028_debug.hex), the bootloader is advertising as "DfuTarg". When I load an application (using Keil or DFU with nrfConnect´), it does not leave the bootloader mode.

Can you tell me whats wrong?

Thank you!

Edit: I use SD130 on nRF51

Parents
  • Hi,

    The bootloader was made so that you would need to program the application via DFU bootloader to make it start.

    If you don't want to use the DFU bootloader to upload your first application, and prefer to use the programmer instead, you need to alter the bootloader setting in flash to tell the bootloader to start the application. You can generate a bootloader setting hex file then write it to flash to do that. Please have a look here.

  • Hi Mr91,

    All your steps looked fine. I need to see the log when you do DFU. You can find the log by openning nRFLogger.

    Also if you have a sniffer trace it would be useful.

    You can also turn off optimization in the project option, re-flash the bootloader and enter debug mode, then you can step into the code of the bootloader and check why the application is not started after you do DFU.

Reply
  • Hi Mr91,

    All your steps looked fine. I need to see the log when you do DFU. You can find the log by openning nRFLogger.

    Also if you have a sniffer trace it would be useful.

    You can also turn off optimization in the project option, re-flash the bootloader and enter debug mode, then you can step into the code of the bootloader and check why the application is not started after you do DFU.

Children
No Data
Related