Uart application

[pavan]

Hello all,

I am working on nrf52832 Board and i want to use it as translator to send and receive the data , please tel which pins i need to select as UART(rx,tx) pins ? How to configure the same?

[Gz]

I recommend you run the ble_app_uart project in the nRF5_SDK_13.0.0_0\examples\ble_peripheral, and the RX and TX are 8 and 6.

[arjun]

Hi, I am trying to config the other GPIO pins as UART RX/TX, as suggested above, but I am not getting any output on realterm. I get output, only when I use default config of 6 and 8(Tx/Rx).

I am working on the temperature example given in peripheral. I am using PCA 10040 Development kit. Are there any other configuration settings, that I need to set??