Hi Guys,
I am new to the nrf52 family of chipsets and started my work with a custom board containing the nrf52832 chip and some on board peripherals like GPS and some sensors.
I got the nordic nrf52 arduino core successfully running on the arduino IDE and was able to program a small BLE peripheral example. I was also able to get some of the on board sensors show up their value in characteristics.
But all this while, i miss a quick glance at Serial data. The code has a few Serial.begin and Serial.print calls but i am not sure how to route these internal Serial.print calls via the JTAG interface. I am using a Segger Jlink module.
My question is, is there a way to do this; i.e. getting the hardware serial data over the jtag. Do i need to do any hardware/software changes to make this happen.
Thanks
Regards narioinc89