sd_ble_gatts_hvx cache

[Stayhungry]

1、how long will it take for me to cache?

Once I call sd_ble_gatts_hvx, assuming tx_queue is large enough, how long can I cache data to softdeivce?

For example, I called sd_ble_gatts_hvx once, and then called again after 5ms. Can I cache successfully,Or the data has been sent out? Why?

2、Cached data and the size of the actual packet sent

If ATT_MTU is set to 247, LL payload = 251, tx_queue = 2, should I get NO_RESOURCE once if I call sd_ble_gatts_hvx(buffer, buffer len = 100) third times ?

This time actually sent the package which payload len = 200byte?

Thanks

[endnode]

1. How long? Doesn't make sense. Tx queue size is partially configurable in Nordic Soft Device and how much time it takes to flush it over BLE that's impossible to say as it depends on how BLE connection link performs at that moment (what is the interval, what is packet loss etc.) So forget about time, there is no guaranteed time when it comes to radio like BLE.
2. Tx queue size in Nordic Soft Device should have "slots" so on (G)ATT layer it can hold certain number of packets regardless the size. So you can get BLE_ERROR_NO_TX_BUFFERS error code in response if you try to push some more outgoing packets but there is no available Tx slot on (G)ATT layer in the SD. The size doesn't matter.

[Stayhungry]

Thanks for your detailed reply.

You mean before the start of the connection event, I have to fill in the tx_queue, and SD will make some necessary preparations for that. At some point, I will receive the TX_COMPLETE event, but this does not mean this time the connection event Has been completed, not even started, but I can already fill the tx queue for the next connection event, so you think time is meaningless, may I understand it?

What do you think of my question 2?