Pairing and Bonding Method in nrf51822

[Hust]

Hi guys,

I am currently using nrf51822 with SDK 11. I use Peer Manage to deal with paring and bonding encryption in BLE connection.

Please correct me if I am wrong but in "Just Work" mode, the nrf51822 connect and bond with any device. For example, Smart Phone A connected and then bonded with nrf51822, then I disconnected the Smart Phone A, after that, I connect and bond the device with Smart Phone B, and it is connect and bond with Smart Phone B right away.

I wonder if there is any way I can do to change it in the way like this: as long as the device nrf51822 stay connected and bonded with Smart Phone A, it can not bond and transfer information to other smart phone unless the device delete bond information with the Smart Phone A first?

I am very sorry for my English.

Thank you for your support.

[Petter Myhre]

Yes, it is possible.

First advertise without whitelist.

Smart phone A connects and does just works bonding. (You have to do this in a safe environment to not be vulnerable to passive eavesdropping and MTIM attacks.)

Then disable pairing/bonding.

If you get disconnected, advertise with whitelist (to filter out connection requests from unfamiliar centrals).

(Be aware that a hostile central can use the address of the trusted central to get through the whitelist and connect, but it will not be able to pair/bond (when this is disabled). However, you will have to detect this and disconnect.)

If the bond is deleted, enable pairing/bonding and advertise without whitelist.

On program startup check if a device is bonded, if it is, disable pairing/bonding and advertise with whitelist, if not advertise without whitelist.

[Petter Myhre]

For whitelisting this might be helpful. There are also a lot of questions about it in here.

This might also be helpful. I would also consider buying a book, for example this one.