nRF24LU1+ Bootloader in nRFGo Studio

[Simon Third]

Hi All,

I've just been trying to program some of my USB dongles, nRF24LU1P-F16, via nRFGo Studio. They are recognised fine, and seem to be operational after programming, BUT....I get "Circuit was not programmed correctly" in the log messages box. Verification does not report positive results either.

I've checked the 16k Flash option but it still gives the same results.

Any Ideas?

Thanks Simon

[Håkon Alseth]

Hi Simon,

1. Which version of nRFgo Studio are you using?
2. Does this verification error happen every time?
3. Have you tried using a different hex file to verify that the one you have is not going into the bootloaders address area?

BR Håkon