nrf52832 not working outside debugger.

[Arne Laugstøl]

Hi

I have a wired situation in my project. Everything is working fine when I am running my heart-rate device with the debugger. When I detach the debugger or just power-cycle the device behaviour becomes wired. The device still advertise, so I can see it from my phone. But, when I try to connect to it from my phone, it will not connect anymore. If I do "connect jLink" from Segger studio, then everything works fine again.

I am using SEGGER_RTT_WriteString a lot, and I suspected that it could be that the output to the debugger via SWD was blocking when I am not running the debugger. So, I have checked in my code that I am doing SEGGER_RTT_Init() at start, and I have set the SEGGER_RTT_CONFIG_DEFAULT_MODE to 0 (i.e SKIP when buffer is full).

I am using nRF52832 with our own HW, Segger Studio and j-Link Ultra. The sdk version 14.2.0.

Any idea where to start looking for a solution?

Regards Arne

[Nguyen Hoan Hoang]

RTT require the JLink be connected all the time. You need to disable RTT for stand-alone.

[RK]

but that's my point - you didn't just say you've found cases you were unable to explain where turning off RTT fixed a bug you couldn't understand. You made the statement that RTT requires JLink to be connected all the time which is just straight up false and not as designed by Segger. The problem with posts like this is someone then does turn off RTT, it randomly fixes the actual bug they do have which is something different and then the incorrect "fact" that 'RTT causes your program to hang if JLink isn't connected' becomes something people find when they search for answers and think it's true. Then people randomly remove RTT, make life hard and never find their actual issues.

If you want to post opinion, go ahead, but at least say 'in my experience' or 'you are supposed to be able to leave RTT code on all the time but I've had some problems with that I never got to the bottom of'.