How many max SPI slave sensor I can connect with Nrf52840 via SPIM

[Chitrang Talaviya]

Hello Folks,

I am using PCA 10056 Eval board. I am using SPIM0 to connect 5 slave sensors. The Chip select is done by the UART Tx pin. So If I send 0x01 over UARt then the sensor- 1 will be selected.

UART Tx byte -- Sensor 0x01 -- 1 0x02 -- 2 etc

Sensors are LSM6DSL

I have five sensors connected via SPIM0 to nordic nrf52840. I am only able to get the reading from 1 or 2 sensors only which is connected closely to nordic. Is there any max limit with the current SPIM hardware and software limitations in terms of max slaves?

ALso, How to change the CS duration and RX delay timing of the SPIM hardware using the SDK 14?

Thank you

[Chitrang Talaviya]

Sorry for the confusion. Lets say five sensors are connected with the SPI bus of the nordic. Each sensor is connected using MISO, MOSI and CSK. Now, for the cheap select, what I am doing is that I am using UART hardware. The UART Tx pin of NRF52840 is acting as CS for all the sensors. Each sensor is connected with the UART Tx pin. If I will send the 0x01 over the UART Tx pin then the sensor 1 will be selected. Its CS pin will go low. Now I will perform the data transfer over the SPI and send 0x00 over the UART Tx pin. Sending 0x00 will make the CS pin of that sensor to high. This is how my CS mechanism is working. I am not using dedicated GPIOs for the CS pins of all the sensors. Instead using just one UART TX pin to act as CS pin for the sensors.