• State Verified Answer
  • Locked Locked
  • Replies 12 replies
  • Subscribers 62 subscribers
  • Views 5606 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 129227
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

There is no debugger connected with the PC. Nrf52840 PCA 10056

Chitrang Talaviya

Helllo, I have PCA 10056 board with me. Somehow, IMy Windows 10 PC is not able to recognize the board. The nrfStudio Go is not able to recognze the board. I remember I programmed board once and now I am not able to even see the board in PC. When I turn on the board the old program is running. When I turn on the board by pressing the RESET button, I am able to see LED5 blinking. Did i erase the bootloader or something. How can I recover from here?

Parents
  • 0

    THank you for the reply. I have connected my board to the PC via USB. then I opened the J-Link configurator and I am not able to see any update in the software. If you turn on the device(PCA 10056) using on-off button then the LED 5 is not blinking. But if you press the RESET/IF BOOT pin and then switch on then the LED 5 starts blinking. THe blinking interval is 1 second.

Reply
  • 0

    THank you for the reply. I have connected my board to the PC via USB. then I opened the J-Link configurator and I am not able to see any update in the software. If you turn on the device(PCA 10056) using on-off button then the LED 5 is not blinking. But if you press the RESET/IF BOOT pin and then switch on then the LED 5 starts blinking. THe blinking interval is 1 second.

Children
No Data
Related