"Tile Pro" Tracker - Impressive Range

[jumpingfool]

I have recently purchased the newly released "Tile Pro" bluetooth tracker after noticing a number of reviews online were giving good reports in terms of the BLE range.

The device is using the TC35678 from TI connected to an RF amplifier that I've been unable to identify marked X8 OZ4D. It also has a pretty funky looking PCB antenna - you can see it in the FCC report here:

fccid.io/.../Internal-Photos-3495407

They claim battery life of 1 year on a CR2032.

Under test the line of sight range from this device is nearly double that I can achieve from the NRF52 DK. Is this a function of the amplifier, the antenna design or potentially both?

If I move my design to the 52840 with +8db output can I reasonably expect to achieve similar performance in terms of range and battery life, or will an RF amplifier need to be incorporated into the design in order to achieve this?

[ovrebekk]

Hi

Was the output power of the nRF52832 +4dBm when you compared it, or was it lower?

I strongly doubt the antenna of the Tile module is better than the one on the DK, due to it's smaller size. If they did a good job tuning it (which I assume they did, judging by the range) it should be comparable.

If the range is double this is most likely caused by higher output power, and double the range equals roughly 6dB higher output power.

To summarize, if the Tile was double the range of the nRF52DK at +4dBm, then I doubt the nRF52840 at +8dBm will be able to beat it, but it should get you close.

As a final note, the TC35678 appears to be a Toshiba part. I wasn't aware they were in the BLE space, but these days everyone is.

Best regards
Torbjørn Øvrebekk

[jumpingfool]

Hi Torbjorn,

Thanks again for your help. After a bit more research I have found this module from notWired which pairs the nRF52832 with the SKY66112 and a chip antenna:

www.notwired.co/.../

I've ordered a couple to experiment with before we move to our own PCB design.

From reading the datasheet I can see that the PA must be toggled between TX and RX mode using GPIO in sync with the radio activity from the the Nordic SoC. Are there any examples/tutorials available that I could use to understand what modifications will be required to the SDK examples to enable them to drive the PA?