DFU not advertising

[jumpingfool]

Hi,

I am trying to get DFU working on my PCA10040 board using SDK 14.2 and armgcc toolchain.

I have followed the instructions to set up DFU here:

devzone.nordicsemi.com/.../

The only changes I have made to the bootloader example are to include the generated public_key.c file in the Makefile - trying to compile the example without this throws an error about the example key not being allowable in production.

The bootloader compiles fine and I've flashed it onto the board along with the softdevice. LED 3 lights which I understand should indicate DFU mode (although LED 1 does not light).

The problem is that the board isn't advertising. If I instead flash the pre-compiled hex file from the example directory then advertising works fine, noting that both LED 1 and LED 3 are lit.

The process is pretty simple so I can't obviously see where I would have gone wrong. Any suggestions would be gratefully received!

This is the generated public_key.c file: public_key.c

And this is the compiled hex file: nrf52832_xxaa_s132.hex

[Matt]

I am experiencing the exact same problem but have not been able to resolve this.

SDK 14.2 clean install. Build at /pca10040/armgcc

Only updated Makefile with public_key.c location

All compile and flash ok... LED3 light up LED1 not, no advertising.

-------

Next tests -

1. Generate different keys and try again. (not sure why this would work)

2. Revert back to GNU ARM tools v6 and test again

RESOLVED UPDATE: after above tests

1. Generating new keys did not work for me.

2. After reverting back to \GNU Tools ARM\6 2017q1-update from c:\GNU Tools ARM\7 2018-q2-update\ and recompiling it seems to have worked. Reminder to update (SDK)\components\toolchain\arm\Makefile.windows