Can I break the module(nrf52832) while program the application

[Mario]

Hello,

I have a question is it possible to break the nrf52832 if I try to load the application when the UART of the module is active(TX and RX pins are 1).

The softdevice is 2.0.1 nRF52832_xxaa_s132 board pca10040 and the example that I used is based on ble_app_multirole_lesc.

Thanks in advance.

[shibshab]

No.

Using the tools given by nordic you should not be able to break the device in any way.

[Mario]

I forgot to tell you that I do not use nRFgo Studio I use the J-Link.exe to program the module if I use nrf nRFgo Studio the program do not let me to program to module if UART is active. If I use a J-Link when the UART is active I can program the module but in that case the module stop advertise and stop response via uart if a reprogram the module with nRFgo studio the problem stays, so in that case is it possible to break the module.