If I leave the CE pin in a HI state, and assuming I have the PWR_UP = 1 and have loaded the Tx FIFO with data, will the data be transmitted by merely setting PRIM_RX to a "0" ?
If I leave the CE pin in a HI state, and assuming I have the PWR_UP = 1 and have loaded the Tx FIFO with data, will the data be transmitted by merely setting PRIM_RX to a "0" ?
Hi
No, this will not work.
You have to disable CE to switch the radio from TX to RX, or vice versa.
If you disable CE, set PRIM_RX to 0, and enable CE again, it should work.
Best regards
Torbjørn Øvrebekk
Hi
No, this will not work.
You have to disable CE to switch the radio from TX to RX, or vice versa.
If you disable CE, set PRIM_RX to 0, and enable CE again, it should work.
Best regards
Torbjørn Øvrebekk