Recommend nRF52832 custom board External Programmer?

[vishal]

Hi Sir,

We have designed custom nRF52832 board in PCB design layout have 4 Pin connector VDD, SWCLK, SWD, GND. I know how to use nRF52832 DK for programming. But for other user we need to only flash first time nRF52832 softdevice, bootloader, and application hex file into nRF52832 using nrf go studio. I do not need to debug custom PCB board. I know j-link programmer but it is very expensive only for flash hex file this mush too costly. I have found ST-LINK/V2 here I have few question on nRF52832 programmer:

1. Can i use this ST link for flashing boot loader, SD, application hex file using nrf go studio software.
2. If yes is it need to convert J link to ST link how detect my custom board in laptop using ST link.
3. Suggest me other nRF52832 programmer it will not more costly.

Thanks......

[vishal]

Thanks for your suggestion,

Can i use this IDAP-Link CMSIS-DAP as a production programmer is it have license.

[Nguyen Hoan Hoang]

Yes, you can use it for production, for debugging on any MCU supported by OpenOCD, Keil, CrossWork, etc... There is no limitation. 

[vishal]

Ok Sir we will try to use this above programmer as a production.

Thanks