Characteristic Larger Than 20 Bytes & and Updating S110

[Lucas]

Hello,

I've been looking at this post devzone.nordicsemi.com/.../ in regards to characteristic lengths.

I'm still not clear on the matter. Currently I have initialized a characteristic to send 500bytes. The system is running, but when I try to look at the data using the Master Control Panel only 20 bytes are received. How would I go about getting all 500 bytes to send?

Also, when migrating from one version of S110 to another I assume that all new header files should be copied over into the include path where the project is linked too. Other than flashing s110, updating code accordingly, and replacing header files is there any additional things that need to be done?

Lucas

[Lucas]

I want to become vulgar

[brianreinhold]

I can understand ... I have a characteristic of 22 bytes in the nrf5840. Peers can't read it unless it is 20 bytes or less. No info in how to set up a 'blob' read. Peer has no problem reading other devices with long characteristics.