• State Verified Answer
  • Replies 1 reply
  • Subscribers 73 subscribers
  • Views 1182 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 201005
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

No response from master emulator for PCA10031

Comodo

Hi everyone,

I have the same problem as the others before me. I have tried everything as described in other topics but it is not working. Have some screenshots below:

So I have tried to flash it over MCP with the latest FW. Then I tried the nRFgo with 0.11.0 FM and it didn't work either. 

I think it should not be that complex to get some HW/SW work. One SW package, one tool,one guide and it should work. Already spent 2 Hours for a sniffer function...

Parents
  • +1

    Hello,

    I have seen someone having problems with uploading the firmware over MCP, so to be sure that isn't your problem, try to use nRFgo Studio, just like you did.

    I suspect the issue is that you have not grounded pin P0.30. It says in the documentation that you find by opening MCP, press "help" --> "open help" --> "Supported Hardware". It is not that easy to stumble upon, so it is a common problem. Did you try this?

    I do recommend you to switch over to nRF Connect for Desktop, as it is easier to navigate through, and it is still being updated. MCP is now "as is", and will not support new features.

    Best regards,

    Edvin

Reply
  • +1

    Hello,

    I have seen someone having problems with uploading the firmware over MCP, so to be sure that isn't your problem, try to use nRFgo Studio, just like you did.

    I suspect the issue is that you have not grounded pin P0.30. It says in the documentation that you find by opening MCP, press "help" --> "open help" --> "Supported Hardware". It is not that easy to stumble upon, so it is a common problem. Did you try this?

    I do recommend you to switch over to nRF Connect for Desktop, as it is easier to navigate through, and it is still being updated. MCP is now "as is", and will not support new features.

    Best regards,

    Edvin

Children
No Data
Related
Terms of service