ble_app_uart_c problem using a WT51822-S4AT board

[samuel.zetterlund]

Hi,

 

I have a couple of WT51822-S4AT boards I would like to use to send data from a PC to one board via UART and then pass the data to a microcontroller connected to the other board via its UART.

So: PC --> n51822 --> n51822 --> microcontroller.

 

I managed to get the ble_app_uart peripheral example working by changing the RX/TX pins and changing the flash layout and compiling for BOARD_WT51822 instead of for example BOARD_PCA10028.

 

Using the nRF toolbox app on my phone I can send data to that peripheral board.

 

But, now I would like to use the other board as a central and I can't seem to get it working. I get stuck in the sd_ble_gap_scan_start function which returns the error code 0x00000007 and then the device is reset.

Do you have any clue why I'm getting this error?

 

 

Thanks in advance,

Samuel

[MartinBL]

Hi, 

Sorry for the late response. 

Have you made any progress? 

If not, what SDK and Softdevice versions are you using? And are you using an example to get started? 

I was not able to find a good datasheet for your module, but if it is this one, you can see that it doesn't have any external LF Crystal, so using NRF_CLOCK_LFCLKSRC_XTAL_20_PPM is out of the question. Using NRF_CLOCK_LFCLKSRC_SYNTH_250_PPM should always work though. 

[Sepehr1989]

Thank you so much.

It was my problem too, but solved