Hi,
I have connected my custom pcb to the development kit at pin 19. When i use jlink commander, the board is detected properly. I use nrfjprog to dump the softdevice(Using s132 2.0.0).It runs fine. However, i cannot detect my custom pcb on the laptop like i detect my nrf52DK. I have to connect the custom pcb to my dk to run the code. However, i do not want to do that. I want the custom pcb to run on its own. I have verified the voltage throughout the board and it is 3.3V throughout. Please suggest me how to go about it.
Thanks in advance.