NRF24l01+ data rate problem

[anny]

I am working on nrf24l01+ which interfaced with atmega32. I received data but it take time to receive (appx. 1min). I set RF_SETUP to 0x27 ,disabling auto ack and sending 5 byte data.I don't understand where is the problem?please help me to solve this problem.

[Håkon Alseth]

Hi,

I saw that you posted this question in another thread as well. Please do not double-post questions in different threads. devzone.nordicsemi.com/.../

It sounds like there's something wrong with your RF configuration. It will never take 1 minute from transmission to reception. Make sure that both PRX and PTX has the same RF configuration in terms of:

• RF address
• RF config
• RF Channel used

Could you post the register map on both the RX and TX?

Best regards, Håkon

[anny]

hi, Sorry for double posting. My PRX andPTX has same RF configuration but still having same problem. Below I am sending my transmitter and receiver code will you help to find the problem?

nrfreciver.c nrftransmitter.c

[Håkon Alseth]

You must clear the STATUS register for every interrupt that you receive. Read the STATUS content, then write the same content back. If not you will stop receiving interrupts.

Best regards Håkon