"SWI1_EGU1_IRQHandler" multiply defined while using Radio Notification

[aircheese]

Hi,

I am looking for the timing of when a connection event will happened. Radio Notification seems the right method for me since it provide an interrupt right before an known time before the Connection event. 

I am using NRF52832, SD 132 V5,  SDK 14.1

While i am following this post (this is quite old back to 2015.) : https://devzone.nordicsemi.com/tutorials/b/software-development-kit/posts/radio-notification

The problems shows up. SWI1_EGU1_IRQHandler is multi-defined in my code and nrf_drv_swi.c

In the post, the interrupt is directly written with " void SWI1_IRQHandler(bool radio_evt)" instead of some handles.

I didnt define SWI_DISABLE1 in my code

I assume that the code is change since the post. Could you give me some advice to fix it?

Thank you for your time

Kind regards,

[aircheese]

I did some research since I posted the question.

It seems like in the "nrf_drv_swi.c", the interrupt has been defined and it is controlled by the SWI_EGU_MIXED and SWI_DISABLE1 macro

In my case, SWI_DISABLE1 is never defined by sdk_config and it should be 0.

The question is should I define SWI_DISABLE1 in some where like sdk_config.h to use radio notification?

[Edvin]

Hello,

Can you please specify what SDK you are working on, and I will look into this. Did you start off with one of the examples in the SDK, so that I can start with the same. If not, I can try to set up radio notification in one of the examples in the SDK that you use.

 

Best regards,

Edvin