Is it possible to change TX address on nrf24l01+ on the fly ?

[EschBerlin]

Hello,

I want to change the TX address or channel "on the fly". Since this did not work for me, I read the following post: "Is it possible to change TX address on nrf24l01 + on the fly?".

After the data exchange via Shockburst with RX A I would like to address RX B and then switch back to RX A. RX B receives only a pair of data from the TX without ACK (with W_TX_PAYLOAD_NOACK).

It is not possible to change the address or the channel. CE is low when changing the corresponding registers and reading the RX payload is complete.

What do I have to do to make either way work?

Many thanks for your help!
Best regards from Berlin, Hans-Juergen Esch

[run_ar]

Hi,

Not sure I understand what you are asking. Did you look at the enhanced shockburst examples in our sdk: \nRFgo SDK 2.3.0.10040\source_code\projects\nrfgo_sdk\enhanced_shockburst_examples