Two i2c slaves connected to nrf52832

[Manoj Hiwarkar]

Dear Sir,

I want to access two slaves viz. MAX30205 & LIS3DH by using nrf52832. The problem is, as per the datasheet the values of the pull up resistors required by both the slaves are different. Max30205 needs 4.7k & LIS3DH needs 10k. So what values of pull up resistors shall I put on the i2c bus ?

Eagerly waiting for your reply.

Warm regards,

Manoj Hiwarkar

[Stian Røed Hafskjold]

What is the bus speed you are going to use? You will probably be fine with just the internal 13k pull-up on the nRF chip for lower speeds.

[Manoj Hiwarkar]

I am using 100khz