How to connect bmp280 sensor to nordic nrf52 dk board

[jah]

I am new to embedded development.
How do i physically connect the sensor to the board?

Is it possible without any additional equipment?
What is important regarding pins and jumpers?

Are there any tutorials on that topic ?

Which example could help me to read sensor data and publish them via advertisment?

I am thankful for any hints and pointers

Cheers,

Hans

[karthikeyan]

hi,

  the best way to connect the bmp280 sensor is in twi. there is examples in SDK-->examples-->peripherals-->twi_sensor and twi_scanner. hope that two examples will be helpful to you.

best regards,

karthikeyan

[jah]

Hi,

thanks for the links to the examples.

But my question was mostly about how to PHYSICALLY connect the sensor to the board.

What is the easiest way ?

Are there any tutorials on that ?

[Joakim Jakobsen]

I would suggest that you take a look in the datasheet for the sensor you are using on how to physically connect to it.

Which pins etc. that you need to connect to should be stated there.

Best regards,
Joakim.

[Ali Rumane]

Hi,

As suggested,

Joakim Jakobsen said:

take a look in the datasheet for the sensor

It's a best solution even if you are new to embedded development.

First look in datasheet and compare it with image below, it may help you.

Configure any GPIO pins as SDA and SCL, look for example as suggested.

karthikeyan said:

SDK-->examples-->peripherals-->twi_sensor

Cheers