nRF52832 Serial DFU - Transfer Init Packet - No Response after "Execute Command"

[c.arndt]

Hi,

I am currently implementing the protocol for a serial DFU, following the instructions given here:

https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter.sdk5.v14.2.0%2Flib_dfu_transport_serial.html&cp=4_0_0_3_5_2_3.

The general flow I implemented is:

Get MTU (0x07) --> Select Command Object (0x06 0x01) --> Create Command Object (0x01 0x01)  --> Write up to MTU bytes of data (0x08 XX .... XX) --> Execute Command (0x04)

Up to "Execute Command" everything seems to work perfectly fine. The problem is, I do not get any response on the execute command - neither a "Response Execute Success" nor any failure. 

Do you have any idea, what I am doing wrong here?

Thanks,

Christian

[lesher]

Are you sending ALL of the .dat file Bytes before calling Execute?

[c.arndt]

Yes I do, I have a .dat file of size 135 Bytes. Wrapping it with "Write ID (0x08)" + Slip encoding I have a total size of 138 Bytes which I am transmitting via UART to nRF.

As far as I could see I have max MTU size of 33024 Bytes (is it possible that I am exchanging big endian with little endian?). However, even half of the MTU size means I can transfer .dat file completely at once.

Might here be some issue?