It is possible to run my code from the flash? i need more space in the RAM for my buffer [8k]
It is possible to run my code from the flash? i need more space in the RAM for my buffer [8k]
Hi, Thanks, I need read 10 burst of 675 bytes from some sensor and analyze the output and send it to my iPhone..
i use the s110 uart_ble_app .
if i create : static int16_t samples[675];
I have a linker errors
Hi, Thanks, I need read 10 burst of 675 bytes from some sensor and analyze the output and send it to my iPhone..
i use the s110 uart_ble_app .
if i create : static int16_t samples[675];
I have a linker errors
You'll have to split the data up in chunks to fit into the RAM area. You're about 17k over the RAM limit as of now. You could save the data to flash, then send that over the BLE link.
There is any documentation or sample project for writing to flash? Thanks
You should look at the pstorage documentation that came with the SDK. There are also a lot of good posts on this forum about pstorage.
How to use all plash pages?With psorage documentation i can use just one page?