Understanding using Rigado Dev board for BMD-350 like nRF Connect does.

[Champagne67]

Hi,

I have successfully used the nRF Connect app with a Rigado BMD-350 Dev Board to send a few UART characters back and forth to a new target device using the Rigado BMD-350 module. 

Now, I need to implement an entire UART protocol on the PC side to test the target device UART protocol.  When nRF Connect first located the Dev Board it downloaded new firmware into it. Can someone please tell me what firmware that would have been?  Also, is the protocol that uses the PC COMxx port between nRF Connect and the Dev Board published and available?

If there is an easier approach to this please suggest.

Thanks, Dave

[Einar Thorsrud]

The nRF Connect for Desktop relies on a DK or dongle, and communicates via the pc-ble-driver on the PC side and the connectivity software on the nRF side. This is an example of the serialization support from the SDK, but with some modifications, which you can see in the hex directory in the pc-ble-driver repo on GitHub.