• State Verified Answer
  • +1 person also asked this people also asked this
  • Replies 3 replies
  • Subscribers 70 subscribers
  • Views 6962 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 206264
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

factory reset nrf52-dk

jowegele

Hello Nordic,

I've acquired several nrf52-dks and I use them almost exclusively to flash with nrfConnect on the PC.

To learn more about nrf programming I started with Segger Embedded Studio, easy installation so far all right.

Now I want to reuse the nrf52-dk with nrfConnect.

What do I have to do?

I asked this some time ago, but cannot find the thread anymore.

I remember this:

- download a binary file named "J-Link OB-SAM3U128-V2-NordicSemi 170724.bin"

- drag and drop it onto the nrf52-dk

- power cycle

BUT: This doesn't work. Do I miss a step? Press the IF Boot Button on power-on?

  • +1

    Hi,

    I think you are confusing programming the onboard JLink LITE debugger and the nRF52. You never need to reprogram the onboard debugger when changing between using the DK for development and with nRF Connect. The only thing you need to do before using the board with nRF Connect is to erase the flash using "nrfjprog -e". Then launch nRF Connect and select the correct board. The nRF52 will be programmed with the correct firmware from nRF Connect automatically (after first prompting the user).

    Details: The J-Link OB-SAM3U128-V2-NordicSemi 170724.bin file that you refer to is firmware for the onboard debugger, which you normally never need to flash manually (with a few exceptions). As you write, you have to press and hold the reset button while power cycling in order to upgrade the debugger chip (it will show up as a USB mass storage device).

  • 0 in reply to Einar Thorsrud

    I knew it can't be complicated but I could find the answer to my problem elsewhere. Thank you! Still I have the impression that the DK doesn't always behave the same way on different PCs and with different nrfConnect Versions.

  • 0 in reply to Einar Thorsrud

    This procedure works well: you have to press and hold the reset button while power cycling in order to upgrade the debugger chip (it will show up as a USB mass storage device)

    But when we try to copy the J-Link OB-SAM3U128-V2-NordicSemi 170724.bin file we get following error:

    There is not enough space on bootloader. 

    How can we solve this problem or are there other possibilities to make a factory reset of the nRF52840 DK board?

Related