This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Unavailability of reference design crstal

Hi

I was designing a custom board for nrf52832. The 32MHZ crsytal mentioned in the refrence design of nrf52832 is not available on digi key. So I am ordering the below given part from digikey with same load capacitance -

https://www.digikey.ca/products/en?keywords=887-1998-1-ND

So let me know if it is a good replacement.

The reference design crystal is this:

https://www.digikey.ca/products/en?keywords=Q22FA12800025 

Parents Reply
  •  You are absolutly correct, I only looked at the standard tolerance @+25degC which was +/-30ppm. It is the total tolerance you need to look at, i.e. Frequency Tolerance (at 25 ℃) + Frequency Stability Over Operating Temperature Range + Aging x Lifetime of the device

    In the case of  8Y-32.000MAAV-T this sums up to:

    (+/- 30ppm) + (+/-30ppm) + N years x +/- 3ppm = > +/-40ppm

    So the crystal you suggested cannot be used with the nRF52832 if you intend on using it for BLE. 

Children
No Data
Related