Mesh: How i send message to group means all provisioned server using new mesh sdk 2.0.0?

[vishal]

Hi everyone,

I am using new mesh released sdk v2.0.0 in that i have successfully run light switch demo using 3 nRF52832 baord. One for provisioner, 2 client, 3- server. 

I have replace on_off server and client model into simple_message server. and i want to sent message to all provisioned server.

But message get only one device in old mesh sdk 1.0.1 at client i set m_clients[GROUP_CLIENT_INDEX] then message is get to all server and also relaying this same message.

But i want to do same in new mesh sdk v2.0.0 in client not have GROUP_CLIENT_INDEX i am using following function for published message:

status= access_model_publish(m_clients[0].model_handle, &msg);

instead of m_clients[0] i have tried m_clients[SERVER_NODE_COUNT] but not get message to all server node.

Please tell me any other configuration or change in client as well as provisioner node.

Thanks in Advanced...!!

 

[Mttrinh]

Hi,

The GROUP_CLIENT_INDEX was the index for the group address. So you need to have your server nodes subscribed to the group address at index SERVER_NODE_COUNT for them to receive the message.

[vishal]

Hi,

Actually i solved this issue by publishing message to my last server node address. Can you please tell if i want published my message to specific node address. How i can set this address in published method.

Thanks....!!! 

[Mttrinh]

Hi,

I'm not too sure what you mean "Can you please tell if i want published my message to specific node address. How i can set this address in published method." Do you want to know if you can publish your message to a specific node address? Can you clarify?

[vishal]

Hi,

I want to publish message to specific node address so how i can configure this address in my code. Which function i use for set publish address in sensor node means client model. 

Thanks...

[vishal]

Another question is can you please tell me if i want provisioned 2 or 3 client in mesh how i can do that.

I have changed in LIGHT_SWITCH_EXAMPLE_COMMON.H CLIENT_NODE_COUNT (2) instead of 1.

But at the time of processioning only one client provisioned when i trying to again it not saying any error only see button 1 pressed nothing happen.

Thanks for your valuable suggestion...