nRF52 >> nRF51

[WilliamJangren]

Hi!

I have created a project for nRF52 DK in Segger Embedded Stuido. I wanted to creat it for nRF51 but there was no eamples to start from in the sdk that supports pca10030 and SES so i started with a nRF52 to get started. So now when im done i want to migrate from nRF52 to nRF51. I found a guid that goes from nRF51 to nRF52 is there any for my case or do i have to try to follow that guide? 

thanks!

[Einar Thorsrud]

I have not seen any such guite. Segger Embedded Studio support was added in SDK 14.1, and the latest SDK with support for nRF51 was SDK 12.3.

[WilliamJangren]

So its not possible for me to run my code on a nRF51 when im using Segger Embedded Studio? 

[Einar Thorsrud]

It should be possible. It is just that Nordic does not support it nor provide any examples.

[WilliamJangren]

Any tips what i should do? I started with the Blinky example in sdk v15. Is there a blinky example for pca10031 in any sdk? If there are i think i can copy my own code to that project i see if it works. It must not be supported by SES. 

[Einar Thorsrud]

I would start off with SDK 12.3 as later do not have support for nRF51. Then you should find relevant information about configuring SES in this blog post.