Now I want to run the python scripts interactive_pyaci.py in Embedded system device, I want to know which version of Python Environment must be install in the Embedded device. Because of the space limit, please give me the earliest version , thanks!
Now I want to run the python scripts interactive_pyaci.py in Embedded system device, I want to know which version of Python Environment must be install in the Embedded device. Because of the space limit, please give me the earliest version , thanks!
Hi,
You need at least version 3.5.1.32, see the table listing the required tools, at Installing the toolchain.
Regards,
Terje
Hi,
You need at least version 3.5.1.32, see the table listing the required tools, at Installing the toolchain.
Regards,
Terje
Hi,
Now I have two NRF52832 development kit, I use one board to provision and configuration the other board. One run the "serial" project, the other run the "light_switch/server" project, then use PYACI to connect the "serial" board. The process
as below :
Firstly:
I use PYACI to provision and configuration the node device , and creat a SimpleOnOffClient, in this step I can use d1.set() to control the node device's light on or off.
Secondly:
I reboot the board which run "serial" project, then the PYACI show Device rebooted.
Finally:
I want to control the node device again, so I reopen PYACI, and do some set up, but when I use d1.set() to control node device, it shows ERROR_REJECTED, the detailed information as below picture. Can you help me to find the reason? If the "serial" board reboot , what should we do to Re-control the node device?
Thanks & Best regard!
Hello Kayson Long,
I would like to suggest you check this thread:
https://devzone.nordicsemi.com/f/nordic-q-a/34254/add-delete-nodes-set-sub-net-function-in-mesh-sdk-serial-example
The key is that: we need to add the publish address for the connectivity device.
And since the node has been configured, we don't need to do configuration again.
Hope this can do help :)
Best regards,
Rick