iPhone does not see device on air.

[Dmitriy L1]

Hi everyone!

I'm trying to write demo application to evaluate how custom services would work on nRF52840 SoC. Problem is that iPhone ( iOS 10 and iOS 11 ) doesn't show device in list of found devices, however there is no problems with Android phones. Moreover, nRF Connect utility installed on iPhone is able to recognize successfully. I'm aware about some restrictions for peripheral devices described in Bluetooth Accessory Design Guidelines for Apple Products and adjusted advertise timings as required:

#define APP_ADV_FAST_INTERVAL          32                                           /**< The advertising interval (in units of 0.625 ms). . */
#define APP_ADV_SLOW_INTERVAL         1216                                         /**< Slow advertising interval (in units of 0.625 ms).  */

#define APP_ADV_FAST_DURATION         3000                                         /**< The advertising duration of fast advertising in units of 10 milliseconds. */
#define APP_ADV_SLOW_DURATION        18000                                        /**< The advertising duration of slow advertising in units of 10 milliseconds. */

#define MIN_CONN_INTERVAL              MSEC_TO_UNITS(500, UNIT_1_25_MS)             /**< Minimum acceptable connection interval (0.5 seconds). */
#define MAX_CONN_INTERVAL              MSEC_TO_UNITS(1000, UNIT_1_25_MS)            /**< Maximum acceptable connection interval (1 second). */
#define SLAVE_LATENCY                  0                                            /**< Slave latency. */
#define CONN_SUP_TIMEOUT               MSEC_TO_UNITS(4000, UNIT_10_MS)              /**< Connection supervisory time-out (4 seconds). */      

Next step I've tried is copying settings from BLE app ANCS SDK template as well as initialization code. It also doesn't help. 

My HW platform and tools:

• PCA10056 development board
• nRF5_SDK_15.0.0
• Soft Device S140 V.6.0.0.
• Device acts in peripheral mode only
• Code runs on Free RTOS. I used "ble_app_hrs_freertos" template for reference. 

Any ideas what can be wrong? 

Thanks in advance!

 

[Mttrinh]

Hi,

Have a look at this post. You probably haven't included the supported services.

[Mttrinh]

Yes. Like it was mentioned in the post i referred to, on iOS you will only see devices that is natively supported by iOS, e.g. HID, HRM, ANCS etc. So you have to have one the UUID of one of these services in the advertisement packet for it to be shown without an app.