service not found

[Rawootray]

Dear all,

 I am using the nRF51822 custom developed board. Earlier it was working fine, but now when I try to connect the BLE with nRF ToolBox APP UART service, the APP is automatically getting disconnect with the BLE by showing "the device does not have the required service" . I have attached the log file of the app.

.

Best Regards,

Rawootray Patil.

[Bjørn Kvaale]

What changes did you make between the time when everything was working & now that it is not working? Which example from the SDK are you currently using? Which version of the SDK are you using?

[Rawootray]

Hello Bjorn Kvaale, I made the changes in the BLE_UUID_NUS_SERVICE, earlier it was 0x0001 (working)  then I changed it to 0x1234 (not working). When I again changed to earlier value i.e 0x0001 then also it is not working. I am using the SDK 12.0 in this I am using ble_app_uart example.

[Turbo J]

Try deleting the bonding. Discovery data can be cached if the Service changed notification is not present, so you might be looking at stale cached UUID here.