Hi
I'm trying to run uart example on nrf6310. I followed following link. devzone.nordicsemi.com/.../ and I defined ENABLE_LOOPBACK_TEST.
it was resulted in blinking led0. it means error. where is it wrong?
Edited:
Hi
I'm trying to run uart example on nrf6310. I followed following link. devzone.nordicsemi.com/.../ and I defined ENABLE_LOOPBACK_TEST.
it was resulted in blinking led0. it means error. where is it wrong?
Edited:
Hi, did you make any changes to the example? I am not able to recreate the error you're seeing. Did you place a jumper on P2.1 and P2.2, and not on RXD and TXD on the board?
You need short P.2.1 and P.2.0 in order for the loopback test to work. I edited my answer with the image showing the jumper placement.
You need short P.2.1 and P.2.0 in order for the loopback test to work. I edited my answer with the image showing the jumper placement.