Hi
I'm trying to run uart example on nrf6310. I followed following link. devzone.nordicsemi.com/.../ and I defined ENABLE_LOOPBACK_TEST.
it was resulted in blinking led0. it means error. where is it wrong?
Edited:
Hi
I'm trying to run uart example on nrf6310. I followed following link. devzone.nordicsemi.com/.../ and I defined ENABLE_LOOPBACK_TEST.
it was resulted in blinking led0. it means error. where is it wrong?
Edited:
Hi, did you make any changes to the example? I am not able to recreate the error you're seeing. Did you place a jumper on P2.1 and P2.2, and not on RXD and TXD on the board?
Thanks Vidar. the loopback test works. but i'd like to check log through uart. and now i deleted ENABLE_LOOPBACK_TEST defined and tested it. but i can't do it because of garbled characters. i edited my question wih the image showing terminal.
Thanks Vidar. the loopback test works. but i'd like to check log through uart. and now i deleted ENABLE_LOOPBACK_TEST defined and tested it. but i can't do it because of garbled characters. i edited my question wih the image showing terminal.