Hi
I'm trying to run uart example on nrf6310. I followed following link. devzone.nordicsemi.com/.../ and I defined ENABLE_LOOPBACK_TEST.
it was resulted in blinking led0. it means error. where is it wrong?
Edited:
Hi
I'm trying to run uart example on nrf6310. I followed following link. devzone.nordicsemi.com/.../ and I defined ENABLE_LOOPBACK_TEST.
it was resulted in blinking led0. it means error. where is it wrong?
Edited:
Hi, did you make any changes to the example? I am not able to recreate the error you're seeing. Did you place a jumper on P2.1 and P2.2, and not on RXD and TXD on the board?
solved by removing a jumper placed from P2.2-P2.3 to CTS-RTS. why was it solved? Please let me know.
solved by removing a jumper placed from P2.2-P2.3 to CTS-RTS. why was it solved? Please let me know.