Provisioning problem when want to use more than 1 client node

[vishal]

I am using mesh sdk v2.0.0 1, 1 client and many server node is successfully provisioned. But when i increase CLIENT_NODE_COUNT (2) instead of 1 only one client is provisioned another client nod is not provisioning. I want to use client model modified as a sensor node and it will may be more. So if my client node increase how i can configure this in provisioner node. I have read some question on same and found need to change net-key is it right? if yes is it necessary to set this net-key for each client node.

We want to make network like this please see image:

Thanks in advanced.......!!!

[Bjørn Kvaale]

If you take a look at check_network_state, you notice that when the client is provisioned, it's device uuid is checked (see m_client_node_uuid). You will most likely need to add another client uuid for the second client node that you want to add. Once you have done that, you should be able to provision the other client node too.

[vishal]

Thanks for your response,

But due to not support low power node in Nordic mesh system yet and also not suitable for large amount of data traffic mesh system, we stop here because we need to sensor node battery power device. Now from suggestion of one Nordic support person we move to use regular ble connection using central and peripheral example for implementing our application. 

Really thank you so much for your great support...!!!