Increase UART Buffers

[Mathew Stein]

Hi,

We have a hardware application that prevents us from using flow control to interface with external hardware. We require the NRF51822 to be able to buffer up to 256 bytes of high speed UART information (around 256k bps) and software buffering is resulting in bit errors. Is it possible to get a ble firmware revision of the software stack that can provide this?

[Mathew Stein]

Here's my problem, even with BLE software stack disabled sending 256 bytes back-to-back at say 115200 bps resulted in bit errors on the UART line without flow control. The problem is exacerbated when using an interupt driven uart methodolgy versus polling. Can anyone confirm they are experiencing the same behaviour?

Edit: I wanted to address your suggestion about disabling the stack. This is something I considered and could be feasible if UART worked reliably with the stack disabled. This has so far not been the case, although performance certainly improved (i.e. a lower but still unacceptable bit error rate) with the stack disabled.

[Ole Morten]

Are you using the Evaluation kit or the Development kit? It seems that the Segger chip on the Evaluation kit could have trouble keeping up if there is lots of UART traffic, but I haven't heard of any issues with the chip itself.