This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF24LU1+ Programming Through USB

Hi,

I have successfully flashed nRF24LU1+ via ISP. Right now, I am validating using USB to download firmware for future production.  Here is the issue.

Our project has a USB hub chip connected to two nRF24LU1+ chips.  I have flashed one of  the nRF24LU1+ with boot24lu1p-f32.hex which I found in SDK. When I connect our board to PC USB, Windows Device list recognized the unflashed  chip as USB Receiver.

In nRFgo Studio, only flashed nRF24LU1+ chip can be recognized.  Therefore, the unflahsed one cannot use USB to download. I read from spec that nRF24LU1+ has factory bootloader.  I am wondering why this issue happens. Thank you for answering.

Parents Reply Children
No Data
Related