Segger Embedded Studio Failed to connect to target

[Apfelsine]

In SEGGER Embedded Studio I am not able to connect to the J-Link anymore.

The error message says No idcode detected.

The J-Link commander program returns the following output:

Not being an Electrical Engineer is there anything I can do to recover my board?

[Susheel Nuguru]

if you have nRF MDK tools installed, then try running

> nrfjprog --recover

if this did not work, them most likely you might have bricked your device.

[DeveloperZ]

Hi Susheel,

What might be the major reasons for this error to occur?