• State Not Answered
  • Replies 3 replies
  • Subscribers 76 subscribers
  • Views 2041 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 207226
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

mass production

Marco Pennacchietti

for the mass production what is the best solution in order to flash the nRF52?

for the mass production can I use DK PCA10040 ?

The DK PCA10040 can be used for dubbug on my the target ?

For flash and debugg on my target I need only to connect SWDCLK, SWDIO, GND ?

Thanks

Marco

Parents
  • 0

    It is also prudent to pin out nReset.

    Strictly speaking a reset command can be sent via SWD, however it is not uncommon for the application code to hang up SWD and thus SWD cannot be initialized. I encourage you to research this on the ARM site if you have doubts.

    I've run into it numerous times with people on this website and connecting reset was always the solution.

    You would be hating life if you had to reprogram 10,000 units in inventory only to find they aren't recognized by the programmer due to the firmware on them.

Reply
  • 0

    It is also prudent to pin out nReset.

    Strictly speaking a reset command can be sent via SWD, however it is not uncommon for the application code to hang up SWD and thus SWD cannot be initialized. I encourage you to research this on the ARM site if you have doubts.

    I've run into it numerous times with people on this website and connecting reset was always the solution.

    You would be hating life if you had to reprogram 10,000 units in inventory only to find they aren't recognized by the programmer due to the firmware on them.

Children
No Data
Related
Terms of service